dthomas6184
About
- Username
- dthomas6184
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
I've gone back and really checked my wireing and all my endstops are connected correctly. I took a short video of it. Both z and x are working as they should be, y is still being difficult.
-
I don't think my printer was a fan of the development firmware, I redid the configuration in .92 and there was some improvement. I'm still having issues with XY homing, Z homes perfectly but Y bounces back and forth ignoring its endstop until it fin…
-
shaiss said: Use a file sharing sure like ge.tt, onedrive, Google drive, Dropbox, etc. Or copy and paste it into pastebin or pastie https://drive.google.com/file/d/0BxhXMLFTwtwyeS1nUVZtVWpnNG8/view?usp=sharing
-
-
shaiss said: For your homing issue. Change the homing direction in FW. If it's checked in the configurator uncheck it. Then it will home to zmax. If that's not your intention you can change the direction in FW too under the respective st…
-
these are 2 new videos showing the movement issues and below is my config.h
-
absolutely perfect! Thank you! Awesome! Glad that helped!!! I went through the entire video last night and setup the firmware as I watched. After it was done I uploaded it and tried moving XY&Z, the movement was much better but there are some …
-
absolutely perfect! Thank you!
-
Thanks for your reply, but your video will not play.
-
Thanks, but that's not entirely what I was asking. I've (as of yesterday) inverted the z axis and increased its homing speed, this at least has it homing in the right direction and moving faster (I can at least see it move now). Now ive run into a p…