VinnyVG
About
- Username
- VinnyVG
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
Thanks for your reply, although not sure what you mean...sorry. To explain better, there is a test piece which prints a to the four corners of the hotbed. Therefore if the printer firmware dictates centre and outer print area... there should be…
-
I found the solution! The problem is that the firmware on Anet motherboard - does not use a real USB connection. After some information passed from a forum - I downloaded - "http://www.prolific.com.tw/US/ShowProduct.aspx?p_id=229&pcid…
-
I found the solution! The problem is that the firmware on Anet motherboard - does not use a real USB connection. After some information passed from a forum - I downloaded - "http://www.prolific.com.tw/US/ShowProduct.aspx?p_id=229&pcid=41 …
-
Keo_Arctar said: Hi @Repetier. I just wanted to try Repetier-server to see what it is, I'm on a machine that will not be connected to the printer so I want to properly uninstall and revert any modifications the installer did. But I'm now disc…
-
I think parallels is an included app on iMac - but I have never used it - I had enough problems Withe Windows XP, Vista and 7 and moved to Apple OS and see no reason to run any windows stuff on my iMac! No matter what I do - when install CH34…
-
Repetier said: You need to disable printer in server to free port for other software. I used a terminal code from a similar thread to this and it removed SERVER files. I did a cold re-boot - I installed CH341 - did a cold boot again -…
-
Repetier said: The start code seems pretty legal to me. No apparent reason to omit the G1 Z15 move, also that would not explain why starting at Z20. Have you tried using repetier-server to communicate and print with. Just to see if it makes a…
-
Harveyyoyo said: I'm using my probe as both min endstop and autolevel. Everything is working fine except the matrix is slightly off. My offsets are correct and I have tried both 3 point and 9 point leveling with same problem. Autolevel is wor…
-
Harveyyoyo said: I'm using my probe as both min endstop and autolevel. Everything is working fine except the matrix is slightly off. My offsets are correct and I have tried both 3 point and 9 point leveling with same problem. Autolevel is wor…
-
I have created a really bad video to show Anet the issue. But I don't expect any solutions. There is something weird about the firm ware. Sorry if this repeat s my post - but I have 2 Anet A8s but the second using a v1 Omni motherboard - which …
-
Repetier said: No idea what firmware you use, but I do not think sd card or usb makes a difference if it gets the same g code. So if there is a difference the usb print MUST have different gcodes send. In host you can define a start gcode as …