› ›

mtys123

About

Username
mtys123
Joined
Visits
8
Last Active
Roles
Member

Comments

  • I ran another test similar to the one on marlin on repetier, and the following thing happened: With 100 steps/mm, can literallty run at any speed, I tested even with G1 E200 F48000 and it spined like a propeller. But as soon as I change the steps/m…
    in Nema 8 Stalls at high speeds Comment by mtys123 May 2020
  • Hello again,  After some time I purchase a propper Arduino Mega 2560 + Ramps 1.6 and DRV8825 for my printer. I'm going over this idea again and I found some issues: I set the driver to run on full steps (withoud any jumper), then I enter the correc…
    in Nema 8 Stalls at high speeds Comment by mtys123 May 2020
  • Autoretract is disable on firmware on both versions. If you want I can upload a video of how it fails, Is like it retracts at the correct speed but inmediatly after it unretracts at a way lower speed.
    in G10 Command Unretracts itselfs Comment by mtys123 April 2020
  • Thanks for the quick answer! The board that I'm using is a very shitty MKS Base V1.4 which is base in an arduino Mega 2560, It doesn't have any jumper to change the microstepping of the motor. All the tests that I mention above were done with no lo…
    in Nema 8 Stalls at high speeds Comment by mtys123 March 2020
  • Great, thanks!, how can i manually set the coordinates for the Z probe correction?
    in Distortion correction to fix ROD LENGHT and PRINTER RADIUS Comment by mtys123 March 2017