› ›

Steelphil

About

Username
Steelphil
Joined
Visits
1
Last Active
Roles
Member

Comments

  • wow that fixed it! I did notice though, I am using the x3 pro, and as far as the online confgurator is concerned, it only allows me to configure up to 4 heater pins, when in fact the board has up to 8 heater terminals.Is this something I could expec…
    in XY Movement after limit switches Comment by Steelphil March 2017
  • I did find this in the confg.h file  #define ENDSTOP_X_BACK_MOVE 5#define ENDSTOP_Y_BACK_MOVE 5#define ENDSTOP_Z_BACK_MOVE 2 I dont know if this would cause the issue though.
    in XY Movement after limit switches Comment by Steelphil March 2017
  • that's the thing, I never changed those values when the issue showed up, and I did do a test to see if this was the case, I se them to zero, and 20mm, and the function works as expected. I did not however alter these values in the config.h file itse…
    in XY Movement after limit switches Comment by Steelphil March 2017