AlexM
About
- Username
- AlexM
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
Thanks! It works
-
Do you have an approximate date for new update with the pipe support?
-
Thanks alot for the answer and support! Looking forward for the next release.
-
I successfully installed tty0tty. It's working. But really hard to install and tune. Now I've other trouble. Few times printing failed because Klipper doesn't support g-code line numbering and Repetier-Server shuffle the lines. For example: source …
-
I tried to set Device|Port option to "/tmp/printer" and "/dev/pts/1" ("/tmp/printer" looks like alias for "/dev/pts/1") but Repetier don't try to connect (just what I can see in interface). Is it possible to manually enter port name? Is it affected …
-
Many thanks for your reply and interest in my question! 1. I checked the server.log and found just this: 2018-01-16 22:50:17: Start logging...2018-01-16 22:50:17: Webdirectory: /usr/local/Repetier-Server/www/2018-01-16 22:50:17: Storage directory:…
-
About second thing - yesterday I found firmware list and added the separate config for klipper. I tried to copy from Marlin and Smoothie but anything didn't connect. May I found a log of the reason why Repetier doesn't connect properly? I didn't fin…
-
Where I can download new version for update? Could you write step by step instruction for updating?
-
Thank you for the answers!
-
I know mjpg_stream has a lot of options. Where I can tune their in Repetier Server?
-
I'm using http://127.0.0.1:8080/?action=stream
-
1. connected thru WiFi (Apple router near Pi ~2m direct visibility)2. 640x480 15 FPS I tested similar configuration with Octoprint - no lags at all. P.S. It's Pro version of Server (I bought license)