hokanp
About
- Username
- hokanp
- Joined
- Visits
- 27
- Last Active
- Roles
- Member
Comments
-
I found out that: I have 3 setting for the filament , Build (35), support (35) AND default (50). So it picked the default value. I change the setting for the default value to 35 and then it worked.I also tried to delete the default , but it comes b…
-
Is this also comming for Cure within Repetier host?
-
Thank youI try to increase the distance. I have a Bondtech extruder with high Power.
-
Thank you for your help=)BR
-
HiThank youI have this code:; Default start code G28 ; Home extruder G1 Z15 F800 M107 ; Turn off fan G90 ; Absolute positioning M82 ; Extruder in absolute mode {IF_BED}M190 S{BED} ; Activate all used extruder {IF_EXT0}M104 T0 S{TEMP0} G92 E0 ; Reset…
-
Problem solved. I thougt it was steps in Cura... but it is mm.
-
HiI found the sliced model, way out in space. It is like 50 meter from the hotbed... When I open a new model it is placed on the hotbead. After slicing it goes of in space. It is sliced whit model and support material. When I start Printing the prin…
-
Also have this problem.I can see the objekt in Place object and slicer. But nothing shows up under preview. Have checked all settings.It is slicing the model, time, layers, materials 1 and 2 is showing in mm.
-
Yes. it starting to get a printer. I have now adjust the voltage on the steppers, from 0,68 down to 0,42. I am going to test later today. It was only the X and Y motors that got hot. One irretation thing is that I have a high frequent tone. it comes…
-
HiAfter your recomandation I changed the code, Everything is now working=))I have another problem, stepper moters get wery hot, deforming the PLA brackets.Is it only to ajust the stepper driver voltage?BR
-
Thanks for your answers. When I am back home I shall test your modifications.BR
-
Problem solved.It was the Ramps 1.4 that had some errors, Tested with Another board and now E0 and E1 is working.Thanks.BR
-
HiTested with a new stepper driver, nothing Changes. If I change to motors from E0 to E1 I can only hear a click in the motors when conecting to E0, E1 is dead.Is there any jumper I have missed on the board? BR
-
HiI also have problem with dual extruders. I am using Bondtechs extruder connected to Rapms 1.4. Ext. 1 is connected to E0 and Ext.2 to E1. Heating of both heaters is working aswell as the termistors. I get both extruders up in Repetier Host 2.0.1 b…