› ›

NickOooo

About

Username
NickOooo
Joined
Visits
3
Last Active
Roles
Member

Comments

  • Repetier said: Make also sure in eeprom that bending correction is 0. It adds and offset to measured values and is used to compensate flexing of bed when measuring but set without need it would also create a growing distance to one direction.…
    in Auto-leveling matrix is off Comment by NickOooo March 2017
  • MartinH said: #define FEATURE_Z_PROBE true //was 0 by default (Nick)this should be #define FEATURE_Z_PROBE 1 //0=disabled, 1=enabled (not sure if' true is recognised) #define Z_PROBE_BED_DISTANCE 3 // assuming this is simply a distance great…
    in Auto-leveling matrix is off Comment by NickOooo March 2017
  • Update After exhaustive testing it appears that the firmware is applying the auto level matrix in the wrong sense. That is to say my gut feeling is that it has an incorrect sign (+ve instead of -ve say) so instead of levelling the bed it doubles the…
    in Auto-leveling matrix is off Comment by NickOooo March 2017
  • Harveyyoyo said: It gets higher on one side. Like the bed is tilted. I have the same problem... When auto levelling is OFF and bed manually levelled prints are perfect.When auto levelling ON, the matrix is correctly generated but the fir…
    in Auto-leveling matrix is off Comment by NickOooo March 2017