PM8471
About
- Username
- PM8471
- Joined
- Visits
- 27
- Last Active
- Roles
- Member
Comments
-
If the servos you are talking about are Teknic's Clearpath servos, then you need Teknic's control program to set the IO pins and the pulse/rev on the servo to step and direction (see manual pg 118). Wire up the step direction and enable to the IO pi…
-
Thanks, I figured it out quickly thanks to your directions on where to look. I'm not concerned about having inverted heater pins as I have the extruder heaters running off of the board's MOSFETS and the bed off of a relay.
-
You might want to look at how Repeteir handles laser controls. It will send a high signal through a declared pin whenever it sees a G1 move. It also has a laser warmup time that tells the machine to wait for the laser to heat up before moving. You c…
-
Repetier said: 1. It is always velocity dependent. In fact default is to power 100% and adjust enery with speed.2. Not really. It is just that increasing E enables laser for that move so you simply slice like for fdm printer. If I'm foll…