3didd
About
- Username
- 3didd
- Joined
- Visits
- 30
- Last Active
- Roles
- Member
Comments
-
hi, sorry to jump in.. why would you use SPI over I2C I2C handles collisions and bus much better.
-
Hi, So we replaced the motherboard, and all of the problems went away....Was not related to the firmware at all, thank goodness. For the Firmware not loading, blank screen.This was caused by not having a watchdog enabled and more than a single lang…
-
Thanks for the update/feedback. I uploaded my existing 0.92.8 configuration file in the the 0.92.9 configuration tool.to see if the new firmware will resolve the bed overheating issue. Are there any changes i need to make....steps.1) upload existing…
-
yes i have a 12864 screen on the printer. So the interesting this is that....As you know the screen has the Target Temp and the Current Temp(what bed is doing now) When the thing is over heating... and bear in mind is only over heats the BED, never …
-
hi, so i checked the gcode file as suggested.... header of file is as follows; ; generated by Slic3r 1.2.9 on 2016-04-03 at 15:25:04 ; external perimeters extrusion width = 0.40mm; perimeters extrusion width = 0.67mm; infill extrusion width = 0.67mm…
-
i did not have anything planned.i saw it was in the configuration tool for the 0.92.8 release, but can't find any details or examples on how to use it.... was hoping for some online examples of how others have used it...i like the idea of being abl…
-
Can i get examples or instructions how you use, configure the manual additions.
-
hi, thanks for the feedback.... The printer works 100%.Printer prints 100% The GUI though has the 0,0 position on the wrong side.would be nice if users can customise.
-
Well changing the xy jerk and y acceleration did not seem to helpXY jerk now set to 10Y acceleration now set to 100, then 500 any other suggestions ?
-
Hey,Thanks for the response...when i checked the setting "#define ALWAYS_CHECK_ENDSTOPS 0", It seems that this was already set to zero....Sorry I was wrong in my previous comment.... "The movement is the away from the Y Axis end stop."The Y Axis is…
-
So I am using the Firmware 0.92.8, and am having an issue where the Y Axis seems to be moving out of sequence.The Y Axis seems to be moving fine for a couple of layers, then the print moves offset a few mm, in the direction of the Y Axis.The movemen…
-
hi,thanks...