jablana
About
- Username
- jablana
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
Using the command M400 solve the problem. G90M82G28 ; home all axesM400G1 Z5G32;
-
The setting for bltouch I setup that it works now, but have problem with autobed leveling. https://www.youtube.com/watch?v=xUnn2WYSRA0&feature=youtu.be Gcode startG90M82G28 ; home all axesG1 Z5G32;....makes error shown in video, beacuse probe …
-
i tried this lines like that and the other way around, but as of now I'm been changing anything about endstops and honestly I do not know what to do next. Tommorow I will try again with new configuration on web site, is possibly better to use old 0.…
-
At this point i must doing something wrong, because i tried to set up in the configuration.h many different setting for zmin and then the same settings for zmax (when i tried to switch between them). Settings the endstop configuration for electrical…
-
I tried to check with M119 and if I use endstop (mechanical) it works; H when triggered and L when not triggered. But then when the Bltouch is connected (on the same pin the same way) it just stay L all the time. I tried to connected on ZMAX pin…
-
Video fixed, any information of possible solution...
-
Hi, After reviewing all topic about BLTouch here on forum I still didnt manage to score a success with my setup. I've got all connected up like shown on picture below.. I have Bltouch, otherwise connected to the pin 39, but basically it works (…