› ›

tamian

About

Username
tamian
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Okay, thank you for all. Do you know someone who know Pronterface on level of source code?  Anyway, thank you very much for whole help! 
    in Problem with Resend:0 through Pronterface Comment by tamian January 2017
  • Okay, I took me a long time, but I tested it out. Both options. Gcode with manually added N line numbers and without it. Repetier prints ok, Pronterface don't. After finish Repetier continues work and send "ok x" where x is incremented each time, bu…
    in Problem with Resend:0 through Pronterface Comment by tamian January 2017
  • It's unlikely that Repetier-Host will show something like that, because after sending g-code file by Repetier and finalize cutting, I can drive machine by Repetier-Host control GUI, but I will check it asap (I don't have machine in my garage right n…
    in Problem with Resend:0 through Pronterface Comment by tamian January 2017
  • Last line in my gcode? It looks like "N3281 M02". I'm pretty sure that line number 0 appears only once, at the beginning.  Surprisingly, Repetier-Host haven't the same problem. But the difference is that Repetier-Host don't show any additional info…
    in Problem with Resend:0 through Pronterface Comment by tamian January 2017