› ›

SvdSinner

About

Username
SvdSinner
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Thanks!  I think I've got my Z--axis working now.  When I started, my max feedrate, acceleration and jerk values were too high.  Adjusting the max feedrate and acceleration did a lot, but until I dropped the jerk value, the stepper motor would spora…
    in Configuring Z-Axis confusion Comment by SvdSinner January 2017
  • Repetier said: Equation might be correct if it is in inches but I think TPI must be 1/TPI depending on what it means. I only use metric units but recognice 25.4 as a conversion.  TPI = Threads Per Inch, Metric threads usually do mm/thre…
    in Configuring Z-Axis confusion Comment by SvdSinner January 2017