josharchibal
About
- Username
- josharchibal
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
@RAyWB I set steps to 400 and it worked just fine !!! waaoou my 1st print !!!!! XD @RAyWB @MartinH @Roko @Repetier I wanted to thank you guys for your help !! Much appreciated ! Enjoy your week-end ! Josh
-
@Repetier : I tried to do what you proposed as follows (step/mm Z axis 2560.00) : 1/ M111 S1 to enable echo 2/ G28 Z (I forgot to write 0 but not big deal since it understood Z0) 3/ G28 Z0 4/ G1 Z0.3 here are the logs : 22:48:20.701 : N99 M111 S…
-
MartinH I measured the pitch. It is 1mm instead of 1.25 mm. Should I modify anything in the settings ? if so, where should I ? Also, after measuring the pitch, I wanted to change the step / mm in the eeprom to see what would happen. So I set Z step…
-
I tried to print again today. Here are the logs : we can see, in red below, (in the logs below) the printer really received G1 Z0.3. The print was unsuccessful because too high from the bed. What I did next is to check if my Z motor delivered the…
-
josharchibal said: Hello, Thank you for the quick reply. I double checked my bed calibration by doing what you mentioned in your previous message. My initial calibration was actually good. What I tried after is the following : afte…