› ›

bsather48

About

Username
bsather48
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Assuming you mean without all of the motors EXCEPT the extruder motor. You could connect to your printer with either pronterface or repetier host and use the GUI to set an appropriate temperature for your filament, then extrude same filament at a g…
    in Way to extrude filament without using motors? Comment by bsather48 January 2017
  • I have my probe connected to zmin. And I have the probe switching the 5v signal that normally comes from the endstop. It looks like this. 
    in Z-probe Creating Incorrect Results Comment by bsather48 January 2017
  • So I tried again without my heated bed turned on, and you were right It was definitely affecting my values. However it is still not correct. I'm not really sure where to go from here.
    in Z-probe Creating Incorrect Results Comment by bsather48 January 2017
  • Repeatability is within acceptable range. However my heated bed was on, seems pretty obvious in hindsight that running what is essentially a giant coil under my sensor was a bad idea.  Thank you so much for the response!! That was a really stupid mi…
    in Z-probe Creating Incorrect Results Comment by bsather48 January 2017
  • These are the bump map before and after results for anyone who doesn't want to use g drive, Thew ones labeled original came from the z-probe, the second set of results was me redoing each point with the paper method. ORIGINAL ORIGINAL 18:30:29.…
    in Z-probe Creating Incorrect Results Comment by bsather48 January 2017
  • Forgot to mention, I am using an inductive probe, not sure if it's relevant but here's the model: uxcell DC 6-36V NPN NO 3-wire 4mm Noncontact Inductive Proximity Sensor Switch LJ12A3-4-Z/BX
    in Z-probe Creating Incorrect Results Comment by bsather48 January 2017