seacuello
About
- Username
- seacuello
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
This code in the console seems to be repeating or hinting at what the communication error may be.. just cant decipher the lines myself -- 13:37:38.751: ok T:195.5 /195.0 B:50.3 /50.0 @:31 B@:18 (2)13:38:09.748: Warning: Communication timeout - rese…
-
when i click on the button with commands enable i see the following: N210 M104 T0 S245 I see this multiple times if I click on the button multiple times. I set the setup temperature value for 245, but if I was to manual type another number in, noth…
-
Thanks for your help, I followed your instructions more closely and have made great progress accessing the 3d printer now.. I was printing earlier, but am not not able to control the printer from the server (hot end does not heat up, and motors were…
-
are you saying to click on the network icon shown on the pi? I'm unable to navigate this screen even with a mouse for some reasons.. also the screen resolution was 800x480, and resolved after editing /boot/config.txt
-
the screen resolution does need to be corrected, i'm unsure what it is exactly but I do have some code for the pi to correct the config.txt file.. After I connect the printer to the pi, do I setup via the web front end on the pi or on another comput…
-
I did try using the precompiled sd image for the raspberry pi, and it booted immediately, but I have now found a new issue for my set up, the attached screenshot shows what I cannot get past and seems to not be connected to the printer.. https://s…