gpau
About
- Username
- gpau
- Joined
- Visits
- 11
- Last Active
- Roles
- Member
Comments
-
bed cradles are correct, I use another 3d printing program, with that I do not create problems, the print runs correctly in the center using the same identical g-code. Perhaps there are other repetier parameters that need to be modified.
-
RAyWB said: seems you did not follow the instructions in the video... so pls read the manual on www.slic3r.org where they explain how to use and configure it. For me it´s impossible to help on pictures or screenshots. Hi, I've fo…
-
RAyWB said: it´s still the same procedure , just watch and follow the instructions Hi, I downloaded the old version but when I load the file.stl in slic3r I get so Photo
-
Hi, I downloaded the old version but when I load the file.stl in slic3r I get so Photo
-
They. Extruders are set but do not print the two colors on the same piece, Last photo below you can see how the press Slic3r
-
Repetier said: And what about slic3r printer setting? Did you set it to 2 extruders? That is the most important thing. Yes
-
This is my setting of Slic3r
-
Repetier said: In mac version this is not possible. That host version can print everything but for creating multi color prints you have to generate the gcode directly in the slicer and not with host slice version. I also tried using the …
-
Repetier said: In host -> printer settings->Extruder you can assign each extruder a color for visualization inside the host. In host -> printer settings-> Extruder I can not assign the color, I did spend the whole program, wh…
-
In what setup I put the colors, I find only in Slic3r> filament and setting a single color, as I post images?