paweueu

Comments

• I tried the dev from: https://github.com/repetier/Repetier-Firmware/tree/development The result: 11:27:44.356 : Error:Wrong checksum 11:27:44.356 : Resend:1667 11:27:44.403 : ok 11:27:44.403 : Resend: N1667 G1 X96.16 Y104.73 E68.1039*104 11:27:44.…

  in Issues with repetier - Error: [steps] Comment by paweueu September 2017
• My happiness didn't last long. Still the same issue... :-( steps error. Maybe it i related to "lag detection" feature?

  in Issues with repetier - Error: [steps] Comment by paweueu September 2017
• Woah! I have left only English and now my LCD works properly. For the first time I see the main screen What is more important I can print with 300% speed without any error messages! Thanks Repetier team

  in Issues with repetier - Error: [steps] Comment by paweueu August 2017
• Hi, My third problem is I can't run 12864 LCD. I can select things in menu but the main screen is corrupted: http://imgur.com/1kTs0GH So I disabled it. #define FEATURE_CONTROLLER 0 It didn't help... I decreased speed to 25% and was able to print…

  in Issues with repetier - Error: [steps] Comment by paweueu August 2017
• Thanks. During reading my EEPROM I have found 2 significant errors. 1) I had Z-height 40mm 2) Alpha C(90) was 80 Also my inductive sensor sucks - when I was testing one point I had different results. The difference in measurements was 0.1-0.2mm …

  in Delta kossel with induction sensor - auto leveling in practise Comment by paweueu January 2017
• I cannot edit my post. I cleared my auto level matrix with M322 and deactivated/activated auto level with m321 S1/ M320 S1. My Z max length is like in EEPROM. When I am creating the "high map" this are my results: 14:01:50.115 : Info:Autoleveling…

  in Delta kossel with induction sensor - auto leveling in practise Comment by paweueu January 2017
• According to hor radius - I executed G1 X0 Y0 command and then measured: What kind of auto level do you use - induction sensor, endstop?

  in How do I use Delta Correction? Comment by paweueu December 2016
• I am still trying. With no success... Every time my dimensions are not correct. Have you changed your steps per mm for each motor? Are you sure your Horizontal radius? Do you use any auto level solution for your bed?

  in How do I use Delta Correction? Comment by paweueu December 2016
• I tried your way, but I am not sure. I entered my values like below Horiz. Radius 107 (I am not sure if this value is correct) D0 - current diagonal 213,84 L (suposed measure) 75 Lx 75.39 Ly 75.04 Lz 74.75 Output for Repetier is: Diagonal rod le…

  in How do I use Delta Correction? Comment by paweueu December 2016
• Thanks Roko, will try with this solution

  in How do I use Delta Correction? Comment by paweueu December 2016
• Hi, I can't set up my printer - the problem is with print size. I tried to print the above linked "caldelta" circle few times. Every time I have wrong dimensions. This is how I am calculating: My print size is: X = 59.9 (reference) Y= 60.27 Z=59.…

  in How do I use Delta Correction? Comment by paweueu December 2016