hmorikawa
About
- Username
- hmorikawa
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
nevermind, today, I tried again and it only had 1 slwo background computation. I think what happened was that I had a 502 bad gateway and using ssh logged in and deleted *.gin files per some recommendation in this forum. Maybe due to that it was r…
-
It's not that I think I cannot print or not. After I upload the gcode, the "Open slow background computation" sign comes up and nozzle icon (icon that shows up usually after upload completes) does not show. Without this icon, I can't print the gco…
-
Ok, thanks for looking into the problem. Hopefully, you will have a permanent workaround for this. I have edited the file but just to let you know the file is in: /usr/local/Repetier-Setup/bin and file is called manageWifiAccess
-
You know what...it happened again. So now I know what's happening but not sure why...I lost connection yeterday night, I checked the /etc/NetworkManager/system-connections/ folder and there should be a config file for my SSID but now it disappeared…
-
Thanks for taking time to read my post and also taking into consideration of adding it into the next release of the Rasberry Pi3 image.
-
I figured out the problem. From my experience, use the wired connection first then open the browser, type in the wired IP address and under WLAN config, select your SSID then you can see the pop-up. Now, problem after this was that after awhile, I…
-
I have same problem. Steps: 1) turn on Rasberry PI3 (of course the latest image i used from repetier site). 2) connect via phone then go to global config 3) select WLAN 4) select my SSID 5) However, I don't have any chance to enter the SSID pas…