› ›

cirorodriguez

About

Username
cirorodriguez
Joined
Visits
3
Last Active
Roles
Member

Comments

  • Thank you very much for your suggestions. In the end I replaced the electronic board and some of the PID parameters and the extruder 1 is working fine. However, I still can't use extruder 2. I have two extruders defined both in config.h and hosts …
    in Temp platoes before target temp Comment by cirorodriguez July 2018
  • Both "PID max value" and "PID drive max" are set to 255. I checked the Graph for output graph but I'm not sure it is really going at 100%. The weird thing is that when I set the nozzle to heat it gets close to the target temp and then fails. But if…
    in Temp platoes before target temp Comment by cirorodriguez July 2018
  • Hello. I've had a similar problem with this error. Increased wait time a little and some other parameters and the error doesn't show anymore. However, I still can't reach the desired temperature. If I set it to 200 the temperature platoes at 180. I…
    in fatal: Heater/sensor error Comment by cirorodriguez July 2018
  • When you say to enable distortion correction manually is there a specific command for it or once I change the z correction at G33 it should correct automatically? I managed to change the values but I don't really know how to make sure it is working.…
    in Manual Distortion Map Input Comment by cirorodriguez December 2016