› ›

GarlanGarner

About

Username
GarlanGarner
Joined
Visits
1
Last Active
Roles
Member

Comments

  • GarlanGarner said: This is my first printing attempt.  Nothing at all is coming out through the heated print head from either extruder.  I see the ABS has entered the print head housing and the motor that pulls the abs through works just fine…
    in Geeetech 301 - Neither extruder working Comment by GarlanGarner December 2016
  • Repetier said: In repetier firmware M32 enables/disables autoleveling. 9600 baud is not correct I think. 115200 or 250000 are the typical baud rates. Try these in host. If you have repetier firmware baud rate is the one set on first upload. O…
    in Trying to setup printer Comment by GarlanGarner December 2016
  • Also.   M321 does nothing.   I suppose that's is designed to center the printer or make everything go home.
    in Trying to setup printer Comment by GarlanGarner December 2016