unknown28
About
- Username
- unknown28
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Direct drive829 steps per mm (calibrated)1mm/s (filament was grinding too much despite nozzle being quite clean)
-
This is the g codeM104 S210 ; set temperatureG28 ; home all axesG1 Z5 F5000 ; lift nozzle M109 S210 ; wait for temperature to be reachedG21 ; set units to millimetersG90 ; use absolute coordinatesM82 ; use absolute distances for extrusionG92 E0G1 Z0…
-
This is the g codeM104 S210 ; set temperatureG28 ; home all axesG1 Z5 F5000 ; lift nozzle M109 S210 ; wait for temperature to be reachedG21 ; set units to millimetersG90 ; use absolute coordinatesM82 ; use absolute distances for extrusionG92 E0G1 Z0…
-
Thanks for the help. While the test didn't show anything, I have indeed done pin reassignment and now things are working fine. I guess I will have to do big checkup to see whats wrong
-
I have been using this printer of a couple of days now and its just started doing this
-
It does that everytime it has to retract
-
I checked that before. All the codes had that at the beginning and the end
-
No need to worry. It turns out that the steps per mm in EEPROM wasn't changed. Than I changed it via the repetier host and now its working. Sorry for the trouble. Thanks
-
The z axis does the auto home pretty well. But won't move manually. So I decided to do a dry run with a part and z axis was way off. But since, the manual controls are not working, I don't know how to calibrate it
-
It does reach z switch and does stops there. But now, it won't move in any direction. It just makes that vibration that it was making before. I switched it with a different motor and now its doing the same thing
-
It did eventually reached home after me repeatedly pressing home. However, it won't move in any direction. It just makes a "tick-tick" noise
-
I changed the steps per mm to 1829 and set everything else to default values. While its moving, its not homing in but would stop without even touching it
-
Ok the z axis is finally moving but it is moving excruciatingly slow. Any solutions?
-
I tried using different motors too but it still doesn't work no matter how low I make all the settings. All it does is vibrate
-
I have tried changing all the setting but it still doesn't workThe steps per mm is 1829 (M12 leadscrew)Homing speed is 2 (I tried 1 but it didn't work)Feedrate is 2 (I tried 1 but it didn't work)homing acceleration is 100 (I tried lower settings)max…