wizzle111
About
- Username
- wizzle111
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
seems i may have fixed it. i reset the positions to a mostly default position, and then cleared the memory and ran g32 s2. the z axis is not moving (barely, which is good and means my bed is mostly level). i appreciate the attempt at help and u…
-
what its doing now, when i print, the z height is not moving up and down, meaning its not adjusting height with the bed. i try and get my bed level, but its not that perfectly level to not have any z movement when its printing. the probe is probi…
-
That seems to have worked as it doesnt seem to be slamming into the endstops.I printed something yesterday and it had text on the front, but it printed in reverse. no idea why as everything was correct except the print. shortly after the x motor sto…
-
I managed to get it to read the new probe coordinates by running m502 (reset to default in firmware) and then m500 (save), but its still trying to exceed the x endstop. Not sure why. any ideas on that would be awesome. at least one headache is go…
-
so i got autolevel to work, sort of. Pullup on high needed to be off to trigger the probe as it basically shorts the connection, so its a low resistance stop. Now, when i issue g32 (without the s2, it probes, but slams into the x axis min endstop.…
-
so basically, i should put the probe on the zmin, and the endstop on the max and physically move the endstop. what do i set the endstop to if its going to be used as a probe? electronic? do the other settings for the probing look fine? does auto…