Basilic

Comments

• on my machine I have 3 positions Position 1: Extruder 1 is 8mm lower than Extruder 2 Position 2 Extruder 1 is 8mm upper Extruder 2 Position 3 Extruder 1 and 2 are at the same level, and probe lower the extruders distance between probe un position …

  in Z Probe Height Comment by Basilic March 2017
• Hello, In my printer, the 2 hotend lift over the probe. The z probe height can be negative?

  in Z Probe Height Comment by Basilic March 2017
• I do it now you can close this

  in Change tools script Comment by Basilic February 2017
• Juste a feed back after a long time. My problem was P3 on X100 Y180 in fact the G32 command use P1-P2 and P1-P3 for coordinated and try to do out of printer.

  in Z probe on positive side of extruder not going to offset position Comment by Basilic February 2017
• I can try to do it, juste says me where (file) is define change tools fonction

  in Change tools script Comment by Basilic February 2017
• Yes I use 0.92 I don't have problem with G32 command. Start position is OK and all working good. My problem is after G32 The head move back off the offset value, but coordinate was wrong (seems offset stay) and when try to go at coordinate X less…

  in Z probe on positive side of extruder not going to offset position Comment by Basilic November 2016
• Hello, after All sorry for my bad english  or french work... I get a similar problem. Repetier-firmware and repetierHost My configuration all start from extruder 0 Extruder 0 offset is X0,Y0 Extruder 1 offset is X-30,Y0 Zprobe offset is X-50,Y0.…

  in Z probe on positive side of extruder not going to offset position Comment by Basilic November 2016