speedy

Comments

• Or do i tell it to ignore eprom settings on startup?Because the X400 firmware eprom settings match the new version i created?

  in Z Axis Motor Moving very slowly Comment by speedy November 2016
• Ignore this dum question, if i had of just opened the software and looked i would have got the answer, which his yes the settings can be changed.Can i change the eprom setting using the Arduino programming software.

  in Z Axis Motor Moving very slowly Comment by speedy November 2016
• Fixed this, i used the complier to sort this, but i now have another issue with i will post separately.

  in Firmware Setup for Fan Extension Board when you are already running 2 extruders and a heated bed. Comment by speedy November 2016