malebuffy
About
- Username
- malebuffy
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
Fore some reason I cannot compile the dev firmware, is it possible to just use BedLeveling.cpp and compile it with the 92.9 files? Or is there more to BedLeveling than just the .cpp file?
-
yes z min is z probe. I am switching to see, although I have managed to get it very close to working (actually quite good). however, with values that don't really make sense...but they work every time!
-
Hello again, thanks for the tip about bending correction. It sure helped. Tricky to align, but worked. It probably has to do with what you said about probing the center of the washers. However I have also another problem. I am using a Malzi boa…
-
I am using 3 large metal washers stuck to the glass plate where the probe measures the distance. the problem is consistent and I will try the bending correction and report back.
-
Hey that worked. I just updated to version under development (1.0) so this was new to me. It wasn't like this on the 0.91 I had I think. Thanks