Mongoose
About
- Username
- Mongoose
- Joined
- Visits
- 28
- Last Active
- Roles
- Member
Comments
-
Just tested it, it's around 30Mbps down/16.08Mbps up -- not AMAZING but certainly not too bad, should still be pulling 1-2mb/s upload. I will add --dev and report back after I do a few tests.
-
Repetier said: I guess you already mailed me the code which I reactivated a few minutes ago. If not send us in an e-mail or pm the license code and we can activate it. Also not unstable PIs are normally a power problem. In latest 0.94.3 serv…
-
Yeah-- it seemed to just keep going, I guess the lockups were it waiting on checksums to fire back, but the printer is in a fatal state? Servers chugging away, but the firmware is locked? Curious why the interface just bombs-- if i try to click emer…
-
I see- so it's not a bug but an intended behavior. Is there a way to restore the old behavior?
-
When I E-stop it, it will recover but seems to have an issue. Bed temp reports 0 degrees, and the printer won't accept any new commands until I deactivate/reactivate. I updated from the menu-- so have not redeployed the image in some time (hard to t…
-
Thanks!
-
It is your image. I fixed it by simply redeploying the update. I guess something got messed up somewhere!
-
Oh, that is the version I have-- my mistake. It's whatever was most recent when updating from the web interface. Annoyingly, I forgot to set my proper time so my logs are a little off. Here's what has come up: 2016-12-08 09:31:36: Start logging..…