› ›

brickmaker

About

Username
brickmaker
Joined
Visits
8
Last Active
Roles
Member

Comments

  • I got it all adjusted and prints looking good. My final question is when i do a prime piller to transition between colors the head waits in one corner of the prime cube and leaves a blob. This is a concern because after a while it is enough that the…
    in x and y have issues Comment by brickmaker October 2016
  • I am printing with abs at 220 with a bed temp of 100. If i need to change the current settings what would i need to change or check? 
    in x and y have issues Comment by brickmaker October 2016
  • I was able to change the eeprom settings using repetier host and changed the x and y acceleration from 9000 to 500. This seems to fix the sound and looks like it is running smooth. BUT when i print a 20mm test cube it bends in plus looks bad. I am l…
    in x and y have issues Comment by brickmaker October 2016
  • This is the eeprom settings. https://www.dropbox.com/s/80o71xgo6pbu1nc/Eeprom.cpp?dl=0
    in x and y have issues Comment by brickmaker October 2016
  • This is the config.h file https://www.dropbox.com/s/tal5zuhwx99e81o/Configuration.h?dl=0 
    in x and y have issues Comment by brickmaker October 2016