› ›

ArnaldoDG

About

Username
ArnaldoDG
Joined
Visits
3
Last Active
Roles
Member

Comments

  • Bullseye!!! EEPROM setting for Y Axis Steps/mm was ZERO!. How come updating the FW did not reset this setting? Anyhow, everything is fine with the cartesian FW. Now let us test the H-Gantry version, which should work fine aswell. Most best regards, …
    in H-gantry Y stepper seems dead Comment by ArnaldoDG September 2016
  • Dear Repetier =] Thank you for your help. I did some testings here even with a cartesian FW.All outputs set to default using config tool 0.92. The weird thing about my setup it that in the Position Fast menu (for X, Y and Z axis), I can see the posi…
    in H-gantry Y stepper seems dead Comment by ArnaldoDG September 2016