Tricubik
About
- Username
- Tricubik
- Joined
- Visits
- 11
- Last Active
- Roles
- Member
Comments
-
I had a look inside the Inkscape extension and modified it. Now it works ;o) The issue happens only when the previous gcode is a G00 and the current move is a small radius (Domingo is right with his analysis). Then the code adds a feedrate instruct…
-
Hello, I have exactly the same issue with the repetier inkscape plugin : it generates lines without space before the «F400» parameter. I observed that it happens always at the begining of a new track, when the first move command is G1. For example i…
-
Repetier said: You can save and it was the right place. Just do not run autodetect afterwards! That overwrites the value. Thanks, I don't «touch» the autodetect afterwards. Now it's ok, I don't have anymore these messages. ;o) Kind regard…
-
Hello, Thanks a lot for your answer ;o) Maybe I am setting up this parameter at the wrong place (?). I mean in the printer settings under the «connection» topic. I have «Input Buffer Size» then «Ping-pong mode» and «Communication Timout» parameters …
-
Hello, I believe I have the same issue, but I can't change the default 3 seconds in repetier server. In fact I can edit it and save the configuration, but when I autodetect from the firmware it comes back to the 3 second by default... So I assume i…
-
Hi, I am using the 92.9 version.I believe that it's the latest version...
-
Thanks for the answer.The display is OK : increasing or decreasing depending on the direction I turn the button.Moreover, when I move manually with the display, all axis are moving correctly in both directions.But for the babby step, the motor are a…