› ›

Ville

About

Username
Ville
Joined
Visits
13
Last Active
Roles
Member

Comments

  • Looks like it must be a cooldown thing, when i placed 30 of them on the bed, the time per part went down to a bit over 6 minutes..
    in Cura doesn't use settings Comment by Ville September 2016
  • Hello! I have an issue with CuraEngine ignoring my extrusion speed settings; i have all speeds set for 70 (which is apparently the maximum for the printer). It does the solid bottom layer at the full speed, but when it gets to the "hollow" part it s…
    in Cura doesn't use settings Comment by Ville September 2016