3dnovice
About
- Username
- 3dnovice
- Joined
- Visits
- 35
- Last Active
- Roles
- Member
Comments
-
I've finally located a firmware which gets me up and running.Everything works well except at the start. In order to get the skirt to start printing I have to give the extruder a helping hand by pushing the filament through the extruder as it travels…
-
After many hours of trial an error finally managed to successfully upload edited Configure.h. This time it took a few minutes to upload and scrolled all data on screen - before, when I thought I'd uploaded, it took only a few seconds and returned an…
-
'M502 M500' did not work.Changed EEPROM_MODE from 1 to 2 - that did not work.The factory set eeprom values for steps per mm on X and Y axes are 78.24 and 78.24, Configure.h values are 80 and 80 - left unchanged during Arduino upload.These values in …
-
Host has nothing to do with your firmware. Firmware can be configured and downloaded here https://www.repetier.com/firmware/dev/index.php Read our documentation for more details and I hope you are not shy of some hacking as sanguino compilations ar…
-
How did you get it for first upload? It is the same and configuration.h is in Repetier subdirectory. I haven't got a first upload.Where is Repetier subdirectory?All I've done so far is install and run Repetier Host.
-
the configuration too requests upload of configuration.h. Where do I find this file? Use the configuration tool. Select a user defined thermistor and the matching editor will appear at the page end.