› ›

jarekp

About

Username
jarekp
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Ech, I found by google something regarding jam detection and it is not just "stop" signal after hardware detect of too much tension of filament, but impulses connected to "flow" of filament (compared with extruder steps). It is very good idea, but n…
    in Hardware PAUSE button Comment by jarekp September 2016
  • Ok, good to know, thanks. I was sure that it is fresh idea, now I see that it was implemented already Could you give me a link, where implementation if this feature is described?  Regarding pause - yes, I know, that I can do it by menu. But I meant …
    in Hardware PAUSE button Comment by jarekp September 2016