mkirby
About
- Username
- mkirby
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
Comments
-
Sorry to hear the the setting changes didn't help. Can you post the gcode file?
-
I just pushed a change to the AlphaHatchboxConfiguration.h to enable software leveling by default.
-
I just changed my notification preferences up at the top where my profile is, I had to check the boxes to email me when comments are made on discussions.
-
I'd love to see the disc!Mine with stock settings is not even possible to print, it prints 2mm high in the air in one spot and dips a lot in the other, so much that it skips teeth. And that's only printing around the perimeter. How is working on the…
-
I did a factory rest (M502), then level (G32 S0), then distortion correction (G33), then printed the disc again.After several loops I canceled the job and dumped the EEPROM (M205). I did a diff between your previous dump and here are only the lines …
-
I'm attempting to print a one layer disc, so far so good. I'll post more pictures here.https://goo.gl/photos/94cafbDHN35J4zMDA SENDING:M205 EPR:0 1028 0 Language EPR:2 75 115200 BaudrateEPR:3 129 620.835 Filament printed [m]EPR:2 125 425733 Printe…
-
I noticed in your EEPROM dump, your radius is different than that of the Hatchbox config.yours: 174.000 Horizontal rod radius at 0,0theirs: #define ROD_RADIUS 176.5 more can be found on my fork, I hope this helps:https://github.com/mikekirby/Repetie…