neoh
About
- Username
- neoh
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
i did, it turned out to be a broken wire
-
I do not, my printer is a Core XY (H style ) printer running repeteir on an ardiuno mega with ramps 1.4.. The printer has worked just fine since I built it 2 years ago... now i am seeing another issue witch leads me to believe its not the firmware, …
-
When homing, I even hit the switch (brand new switch) manually when the gantry was moving to home position, Repetier is getting the signal that it is High but gantry still continues moving.. I changed the switch out thinking it was just a bad switch…
-
Repetier said: Check config file. There is a max. extrusion length per move. I think that is around 100 normally. So maybe your move is just longer and move is ignored. So you can split up move into 2 moves or increase limit. Also make sure t…
-
Repetier said: Check config file. There is a max. extrusion length per move. I think that is around 100 normally. So maybe your move is just longer and move is ignored. So you can split up move into 2 moves or increase limit. Also make sure t…
-
thank you
-
Repetier said: You can add messages using M117 but they may get overwritten by status messages or print progress if enabled. So you can only add some but not change existing messages. Are they not defined in one of the files loaded into Ar…
-
Thank you,, I will have to find out what set of pins are for servo on my zrib board
-
I got around the problem by connecting the switch directly to my Raspberry PI running Octoprint using the runout plug-in. The raspberry then sends the pause to the printer.. Works well this way.. Thank you for all your help...
-
I also would like a good tutorial on adding the BLTouch to Repetier. Repetier has got to be the worst firmware for finding good tutorials on....
-
That was the problem,, thank you....
-
I have changed my #define ZAXIS_STEPS_PER_MM 1600 up and down but still only 2 mm when i tell z to move 10 mm