› ›

Jannie

About

Username
Jannie
Joined
Visits
12
Last Active
Roles
Member

Comments

  • Repetier said: No, print quality will be more or less identical. 1.0.4 has some more functions, but the motion simulated is more or less identical. For better quality you need 32 bit board and better stepper drivers with higher resolution. Be…
    in Upgrade --- Is it worth it? Comment by Jannie October 2021
  • Repetier said: Before any moves all motors are power less that would be ok. Question is how it is after a move like homing. Also check in eeprom values. There you override the config value. Thanks. Now that I know it is OK for motors to …
    in Y stepper has no current till print starts. Comment by Jannie July 2020
  • Thanks for the reply.  Just to make sure, I checked the other motors as well, and it is indeed the SAME for X axis and the extruder as well. NONE of them gets current until the print starts. (X,Y and Extruder) I then checked  stepper timeout period,…
    in Y stepper has no current till print starts. Comment by Jannie July 2020