› ›

calmissile

About

Username
calmissile
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Thanks for the prompt response.  I am not new to CNC but am new to 3D printing.  I am not familiar with 'move back' after homing. I do understand the probe to do the Z-Axis sensing and the photo-optic sensors to sense X and Y axis reference points. …
    in Repetier 0.92 on Da Vinci 2.0A Comment by calmissile August 2016
  • After several days messing around with various versions of Arduino I was finally able to get the Duo 2.0A flashed.  I ended up using Arduinno 1.5.8 and Repetier .92 Master firmware.  It seems to be the only combination that matches the procedures. T…
    in Repetier 0.92 on Da Vinci 2.0A Comment by calmissile August 2016
  • I forgot to add that I contacted Simplify3D about using their software with the Repetier firmware for the Duo 2.0A and they emailed me a couple files that configure their software for the DaVinci printers.  This should make it a lot easier to integr…
    in Repetier 0.92 on Da Vinci 2.0A Comment by calmissile August 2016
  • Not sure why this thread has not been updated recently.  The DaVinci Duo 2.0A printers are selling like hotcakes and I purchased two of them. Like eveyone else, I love the printer but hate the XYZ software/firmware.  I have been using the printers w…
    in Repetier 0.92 on Da Vinci 2.0A Comment by calmissile August 2016