Sparrow77

Comments

• doesn't seem to work, I have followed a few different tutorials and looked online a bit, and cant find the right folder to put into the hardware of the Arduino software.

  in Printer comes up as a different make and model Comment by Sparrow77 May 10
• So it looks like everything works fine when uploading the firmware on the printer, but when the upload is complete, I keep getting notifications that the usb device is not reconized, printer is still on the flashed state. could this be because I hav…

  in Printer comes up as a different make and model Comment by Sparrow77 April 30
• I noticed that I need to have arduino 1.5.8 installed, but when I open the file from github, there is a 1.6.9 and a 1.8.0 version, not a 1.5.8 would that change anything?

  in Printer comes up as a different make and model Comment by Sparrow77 April 27
• do you mind sending the link so I can use the right one, I don't want to download the wrong thing.

  in Printer comes up as a different make and model Comment by Sparrow77 April 24
• I am using repetier 0.91 for firmware, not sure if that is too old

  in Printer comes up as a different make and model Comment by Sparrow77 April 22
• would you know where the output would be for the heater on the Da Vinci 1.0A?

  in Printer comes up as a different make and model Comment by Sparrow77 April 22
• Sparrow77 said: are you talking about the temp readings? when I am in the manual control of the printer, the bed wont heat up to the set temp. is there a way I can send you a  screen recording? sorry for the load of replies, I turned on t…

  in Printer comes up as a different make and model Comment by Sparrow77 April 21
• Sparrow77 said: Sparrow77 said: are you talking about the temp readings? when I am in the manual control of the printer, the bed wont heat up to the set temp. is there a way I can send you a  screen recording? when I turn on AC…

  in Printer comes up as a different make and model Comment by Sparrow77 April 21
• Sparrow77 said: are you talking about the temp readings? when I am in the manual control of the printer, the bed wont heat up to the set temp. is there a way I can send you a  screen recording? when I turn on ACK, I can see that it is sen…

  in Printer comes up as a different make and model Comment by Sparrow77 April 21
• are you talking about the temp readings? when I am in the manual control of the printer, the bed wont heat up to the set temp. is there a way I can send you a  screen recording?

  in Printer comes up as a different make and model Comment by Sparrow77 April 21
• Repetier said: Where do you see the Mendel model name? In M115 response? That is actually not relevant for heated bed. It is just coming from firmware as name. More important is that the firmware is configured to have a heated bed and report …

  in Printer comes up as a different make and model Comment by Sparrow77 April 20