› ›

pierrealexb

About

Username
pierrealexb
Joined
Visits
8
Last Active
Roles
Member

Comments

  • I, just to inform you that the problem is solve with the last repetier update. (nice design btw!!) Thanks!
    in Output extruder Comment by pierrealexb April 2017
  • What do you mean by:? So probably your have set wrong inputs for sensors and showing wrong temperature? How can I change that in RH?
    in Output extruder Comment by pierrealexb April 2017
  • I just heat it for few seconde. Any way, the output extruder problem is still present when the hot end is assembled, even with an other printer on an other computer. Could it be the order of the info of the M105 response wich is not good? The proble…
    in Output extruder Comment by pierrealexb April 2017
  • Hey! You are right about the room temp, I needed to deassembly my hotend because of some other troubles, so the termistor is not stuck to the heater. But is become hot when I ask for, so the pin is good. I have the same output problem with an other …
    in Output extruder Comment by pierrealexb April 2017
  • I put my post in "bug report" category but maybe is not... Sorry for that!
    in Output extruder Comment by pierrealexb April 2017
  • I I have a similar problem, After killing job, repetier always send the head to X0 Y0 even when I write this custom action when killing: G91 G0 Z5 G90 G28 X0 Y0 My park position is X159 Y150 Z0 Does it possible to cancel this movement? Thanks!!…
    in Host 1.0.5 Go to Park Position After Job/Kill Does Not Comment by pierrealexb November 2014