› ›

Rustywonder

About

Username
Rustywonder
Joined
Visits
2
Last Active
Roles
Member

Comments

  • FYI this was my introduction to 3D printing. The DIY printer from Hobby King is what I am using. If the newer versions of Repetier Host will not work with this, I am going to put my own controller together. I have the components but until I have fin…
    in SD card print failure Comment by Rustywonder August 2016
  • Thanks for the reply, It does return the gc. extenstion. That is what was really confusing me. I went ahead and installed version 1.6.0 and amazingly it works again. I save the .gco file to the hard drive then transfer to my SD card on all occasions…
    in SD card print failure Comment by Rustywonder August 2016