Archie

Comments

• The answer is ROD_RADIUS.   Managed to find out from a Thingiverse user. Lower the value to lower the edges.  Raise the value to raise the edges. What this let me do was get my centre correct, then fine tune the edges to match.  Now I know it's leve…

  in How do you compensate for Concave / Convex like Marlin FW? Comment by Archie August 2016
• Never mind.... Solved it.  RTFM One of my extruders is bust, so I still had the offest for the second extruder, so the Firmware was behaving as it should, however it was not centered for one extruder. Once I set for one extruder, it homes just fine…

  in Homing my Geeetech G2S Pro - Z OK but X and Y lag behind. Comment by Archie August 2016
• Just testing this now, and noticed if I don't Home the printer, but manually move the Z position up, I can only trigger all the microswitches if I move Y to -6.00, this seems to line up the sliders and all microswitches are then triggered. Not sure …

  in Homing my Geeetech G2S Pro - Z OK but X and Y lag behind. Comment by Archie August 2016