shaolin30
About
- Username
- shaolin30
- Joined
- Visits
- 24
- Last Active
- Roles
- Member
Comments
-
Hi @MartinH, Thanks again for the response. I've tried your suggestion but when I home Z, I got the same error right away. Earlier values are better I think this time. What could possibly wrong with my printer? Am using 1.0.3 FW version.
-
Thanks @MartinH for the reply. I changed the values of my configuration based on what you have suggested but still am having the same issue. I have prepared a video to see exactly what is going on with my printer. in case of probe Z home I have pu…
-
Repetier said: flickering could be a contact problem? What is flickering exactly? Backlight some chars getting mixed, ... This on also: from the repetier's configuration, I've selected this #define FEATURE_CONTROLLER CONTROLLER_SMARTRAMPS …
-
This is what I'm talking about, I hope you can see it from this video:
-
Yes it is but I can't get it to work with ramps1.4. The screen is only flickering and no information displayed. It's working perfectly with gt2560 but not with ramps1.4 board.
-
I've counted all the pulley's teeth both X and Y and it's exactly 20tooth pulley. Right now I'm just using the 71.4 steps/mm value for Y axis and printed a 20mmx20mm cube for test and the result is weird because Y-axis measured exactly 20mm but X is…
-
Hi, thanks for the response. I'm having problem with my Y axis movement. I have 1.8deg motor, 1/16micro stepping, 20tooth pulley and this belt I bought from ebay: http://www.ebay.ph/itm/New-GT2-Timing-Belt-White-PU-Steel-cords-For-3D-Printer-6mm-wid…
-
figured out