› ›

Ian

About

Username
Ian
Joined
Visits
14
Last Active
Roles
Member

Comments

  • Shaiss I am not able to identify the flag in the FW for inverting the out of filament switch. I'm replacing my micro switch with an optical sensor. Now it Repetier FW shows out of filament when the filament is in and vise versa. I searched through…
    in Out of filament Sensor Comment by Ian August 2017
  • Thanks Shaiss I'll try this...
    in Out of filament Sensor Comment by Ian April 2017
  • I have a Da Vinci 1.0a, with Repetier FW. I'm modifying my Da Vinci  1.0a filament sensor. I changed my direct extruder to a Bowden extruder. I'm adding a micro switch to the Da Vinci sensor port, integrated in the extruder housing.Is the port activ…
    in Out of filament Sensor Comment by Ian April 2017
  • I managed to "solve' the matter. One needs to change two lines: These are all in Configuration.h 1) Leave this as is : #define REPURPOSE_FAN_TO_COOL_EXTRUSIONS 0 2) Then further down: #else//  #define FAN_PIN -1//  #define FEATURE_FAN_CONTROL 0  #d…
    in Unknown command: M106 & M107 Comment by Ian January 2017
  • Martin The problem persists... In my "D:\Arduino\Repetier-Firmware-0.92-master\src\ArduinoDUE\Repetier\Repetier.INO" // ################## EDIT THESE SETTINGS MANUALLY ################ #define DAVINCI 1 // "0" if not DAVINCI, "1" For DAVINCI 1.0, "2…
    in Unknown command: M106 & M107 Comment by Ian January 2017
  • Thanks Martin I'll investigate...
    in Unknown command: M106 & M107 Comment by Ian January 2017
  • Hi JustMe I have a Davinci 1.0A and is quite satisfied using it with Reptier 0.92 and Slic3r. So no scanner on mine. Q5) No comment. Q4) When you turn on the printer, the firmware version is shown on the display. But yes, to reflash, you need to hit…
    in Davinci 1.0 AoI w/ Repetier Comment by Ian October 2016