Hotwire
About
- Username
- Hotwire
- Joined
- Visits
- 26
- Last Active
- Roles
- Member
Comments
-
I think I have found the issue. D1 had a VERY high resistance in both directions. I swapped it out, and moved from a 1.8amp power supply to a 3amp power supply. I think the combonation of a bad diode and an unsatisfactory power supply may have been …
-
Thank you, that's exactly what was happenening. Even if I had it already homed, it would try to re-home PAST the current position. I put in the G1 X100 y100 F6000 it would move to the X100 and y100, THEN it would re-home and start as if it was norma…
-
It was the slicer config that was the issue. I spend a good 4 hours on this last night. The Cura slicer was not accepting anything other then the default profile. Even though I selected my own profile for the slicer it would revert to the default se…
-
Looks like I can make it run off of JUST the USB, but I cannot negate the use of USB power. Im wondering if I just lift the power pin on the USB jack on the arduino...
-
Im using a ramps 1.4 board, and arduino mega.... Any idea how I can force it to use the internal power only? I tried getting the Pi2 to turn off USB power for the reason, but I am unable to do that.
-
I have tried again, and again. Updating the firmware, updating the EEPROM, updating the Software on my computer, and even reinstalling the software on the OctoPrint server to see if THAT made any changes.. Nothing. Its still dropping the bed to 50c …
-
So, I did as you said. I updated the EEPROM. So now it doesn't crash on the 3rd point. What it DOES do is it tries to go past the MIN switches for a second, then moves to the first point. BUT.... If I have NOT homed the X,Y it promptly moves to the …