› ›

mcescher

About

Username
mcescher
Joined
Visits
5
Last Active
Roles
Member

Comments

  • Hello Again! I managed it to work.  Somehow, the probe sends "L" but it goes "H" when homing and G32.  So, it "kinda" works. My problem is now, when I try to print a test piece after g32 s0 (which is one layer-high square with diagonal lines, the no…
    in Yet another Z-Probe Problem Comment by mcescher July 2018
  • Wiring is also correct. I wired the probe according to Ramps 1.4 documentation.  So, no problem there, either.
    in Yet another Z-Probe Problem Comment by mcescher July 2018
  • It does, yes. When I send M119, however, it does not show H even when I move the pin with my fingers.  How odd?
    in Yet another Z-Probe Problem Comment by mcescher July 2018
  • Here it is... Thank you for the reply!
    in Yet another Z-Probe Problem Comment by mcescher July 2018
  • /*    This file is part of Repetier-Firmware.     Repetier-Firmware is free software: you can redistribute it and/or modify    it under the terms of the GNU General Public License as published by    the Free Software Foundation, either version 3 of …
    in Yet another Z-Probe Problem Comment by mcescher July 2018
  • And... I am using Ramps 1.4
    in Yet another Z-Probe Problem Comment by mcescher July 2018
  • Stupid me... I pulled the cable, untangle, and pushed back to its slot. Suddenly, I saw smoke coming out from the circuits.  Well, I think I fried something... I guess I have to buy a new set.Thanks anyway.
    in Y Axis Wandering Comment by mcescher June 2016
  • Hi,Thank you for the reply. I am using 0.92.9 firmware.And, yes... My endstop is on left side.  I will try to separate the endstop wires from the cable spaghetti.  I will also check how to disable endstop check...I checked, double checked the slippa…
    in Y Axis Wandering Comment by mcescher June 2016
  • Sorry, actually it is the X Axis, not Y.
    in Y Axis Wandering Comment by mcescher June 2016