robindegen
About
- Username
- robindegen
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
I've had the same issue. Twice with about half an hour in between. It got so bad that after it stopped, the layers got misaligned and it continued printing about half a centimeter to the right. I used repetier directly connected and that has worked …
-
In order to flash the firmware on the k8200 arduino board (arduino 2560) you must indeed connect/jumper the 2 pins on the header that says "jprog". This is also described in the manual which can be found here:http://www.k8200.eu/downloads/files/k820…