mjhall29
About
- Username
- mjhall29
- Joined
- Visits
- 60
- Last Active
- Roles
- Member
Comments
-
i was being stupid, what was happening was my radds control was getting powered from the usb when i turned on the 24V the radds drooped the link to the server and the gcode file went from active to in the waiting que. i just added @autostart_next_jo…
-
Thanks, I want to be able to turn my printer on at the start of a gcode file completely unattended . I can switch it on no issues but i need the gcode to wait for it to start. it sends the code to heat the bed before the radds board has started so t…
-
yes i spelt repetierserver wrong in my visudo file, too many e's thanks for the response.
-
forgot to say repetier server pro 0.86.2
-
Thanks found it and cleared the files Regards Martin
-
Thanks
-
Thanks That was it, I knew it was operator error, 2 days trying things. I seem to have set the baud rate to a speed i would not have used normally? i found it after you reply by starting at the top and going down the list. Is there any way to find o…
-
Thanks will check that now.
-
this is not correct please see next discussion
-
Yes I am on the issue 0.75.1 pro.This only happens sometimes, yesterday it was on layer 0 for 260 layer print today it is OK it says it is one layer behind the slicer but that's fine, I just took it that the slicer starts at layer 1 and the firmware…
-
Ok But most of the time my software says layer 0/layer count.At the present time both the 20x4 lcd and the server software say layer 0/260 the Z height is correct at 1.9mm. The strange thing was it was working until i put in the licence for the ser…