ZMan

Comments

• Thank.I will wait for the update;)

  in Repetier-Server for farm Comment by ZMan May 2019
• I would like that there was an item in the menu - Bed level. So that the printer moves through four points for calibration.

  in manual bedlevel Comment by ZMan July 2017
• I have a similar question.How to enable manual calibration on four points? For manual adjustment with four screws?

  in manual bedlevel Comment by ZMan July 2017
• Its hardware problem. I'm change "smart controller" and all work good. Pls close topic. 

  in SD read error (Firmware-0.92.9, ramps 1.4) Comment by ZMan May 2016
• UPD. I tried different memory card. The problem is repeated.

  in SD read error (Firmware-0.92.9, ramps 1.4) Comment by ZMan May 2016