rcrocket33
About
- Username
- rcrocket33
- Joined
- Visits
- 18
- Last Active
- Roles
- Member
Comments
-
I used m666 because me bed is unlevel. My auto probe does not work so I used m666 to in a sense make my bed level when the m666 is put into play. My EMPROM is disabled so I figured I could include the m666 i the start Gcode? I guees my question is i…
-
I did check the Gcode and everything seems okay. I attached a copy of my Gcode to see if you see anything fishy. It is the first 30 lines. ;Generated with Cura_SteamEngine 15.01; Default start codeG28 ; Home extruderM666 X-1.8 Y-.87 Z-3.3G28G1 Z1…
-
Yes it still handles Gcode commands and it still moves. I heat up the extruder and load my part I want to print. I then press print and it homes then travels down to 10mm above the bed or something as it always did to make sure the extruder temp was…
-
Okay my bad. Thanks.