rdb9879

Comments

• Thanks for the input. I did manage to communicate with the device and read out the firmware version so I'm guessing this is a hardware issue. I'll try troubleshooting that route.

  in No more movement Comment by rdb9879 October 2022
• Already figured it out. 'sudo apt-get install repetier-host' and 'sudo apt-get install slic3r'. I couldn't get the repetier-host to directly connect to the repetier-server like the Windows version does, but all I had to do was save the g-code files …

  in Repetier-Host on raspberry pi? Comment by rdb9879 May 2021
• I managed to get it working. Here's what I did: Using the web front end, I downloaded the printer settings XML file, deleted the printer, created a new printer, and uploaded the exact same printer settings XML file. I forgot to disconnect from the R…

  in I can connect, but no printer movement Comment by rdb9879 September 2017
• A few updates: I see nothing listed in the Server tab before or after I click "Print." I looked on the Web front end, and if I'm looking in the correct spot (Print Tab, Stored G-Codes), I see nothing. I think I was mistaken in my original post whe…

  in I can connect, but no printer movement Comment by rdb9879 August 2017
• I'm using whatever the raspberry pi 3's default browser is, but it doesn't seem to have networking issues outside of the server. Example: I can go on youtube and watch videos pretty seamlessly

  in Can't delete printer (raspberry pi) Comment by rdb9879 June 2016