› ›

Cyber_One

About

Username
Cyber_One
Joined
Visits
39
Last Active
Roles
Member

Comments

  • May be a bug somewhere,When running from an SD Card, the Set to Origin doesn't change the print off set at all. The G-code was created the easel program on the inventables site and references the work material as Z=0 on the top. Engraving is then do…
    in LCD Set to Origin Comment by Cyber_One May 2016
  • Running RAMPS1.4 with Reprap discount graphics controller.Had trouble with the SD as well.Found somewhere else in the forum, that using old slower SD cards, or some of the dodgy Chinese SD cards, it won't work, as if no cards installed. Tried a clas…
    in Problems to get SD Card work. Comment by Cyber_One May 2016